Filter
Top Products
FINAL ART 5/5/05
& Associates, Inc. Job # 0023671 Size:10.75
"
x 8.25
"
(PAGE 5.375
"
x 8.25
"
) Art Built @ 100% PAGE SIZE Colors: B/W
6
We recommend washing before initial use.
Before Washing or Storing Your Warming Product:
1 Disconnect power cord from wall BEFORE detaching control cord from the warming product.
2 Ensure that no cords are still connected and none of the wires have worn through the fabric.
3 Carefully follow all washing instructions or your warming product may shrink and possibly
cause a fire hazard.
• DO NOT submerge control in water.
•
DO NOT dry clean your warming product. Dry cleaning solvents may damage the wires.
•
DO NOT use bleach or cleaning fluids.
•
DO NOT use a wringer.
•
DO NOT iron your warming product.
•
DO NOT use mothballs or sprays of any kind.
•
DO NOT reconnect the warming product or use it until it is COMPLETELY dry.
•
DO NOT wash or put into water the power cord or any of the product’s cords.
Taking care of your warming product is easy and safe as long as you follow a few simple steps.
Machine Washing
1 Presoak the blanket/mattress pad/throw for 15 minutes in mild soap and lukewarm water.
2 Wash in mild soap and lukewarm water on the “delicate” or “gentle” cycle in the washer
for two minutes. Remember, do not use bleach.
3 Rinse in fresh, lukewarm water.
4 Spin dry in the washing machine. Then gently stretch to its original size.
Machine Drying
Caution: Do not use commercial dryers or the dryers at your local Laundromat.
They get too hot and would damage the wiring of the warming product.
1 Preheat the dryer on the “low” temperature setting for 2 minutes.
2 Place blanket/mattress pad/throw into the dryer and tumble dry for 10 minutes at a low temperature.
3 Remove the blanket/mattress pad/throw while it is still damp and gently stretch it to its original size.
4 Drape the warming product over a clothesline or a shower rod. DO NOT use clothespins.
5 Warming product must be COMPLETELY dry before reconnecting the power plug or control plug.
Hand Washing
1 Presoak the blanket/mattress pad/throw for 15 minutes in mild soap and lukewarm water.
2 Gently squeeze the soap suds through a few times.
3 Rinse in fresh, lukewarm water.
Hand Drying
1 Gently stretch the blanket/mattress pad/throw back to its original size.
2 Drape the war
ming product over a clothesline or hang over a shower rod. DO NOT use clothespins.
3 Warming product must be COMPLETELY dry before reconnecting the power plug or control plug.
Care and Cleaning OF YOUR WARMING PRODUCT
For questions or support, please visit: www.sunbeam.com