Filter
Top Products
FINAL ART 5/5/05
& Associates, Inc. Job # 0023671 Size:10.75
"
x 8.25
"
(PAGE 5.375
"
x 8.25
"
) Art Built @ 100% PAGE SIZE Colors: B/W
1 Place the heated blanket/mattress pad on the bed with the label at the foot
of the bed facing upward.
2 Make sure the cord is connected into the module at the bottom of the
heated blanket/mattress pad until the plastic hinges click into place.
CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire could
result from a loose connection.
3 Run the control cord on the floor under the bed. Do not sandwich cord
between the mattress and box spring. Avoid any tangling or pinching.
4 Control Placement:
• Dual Control for heated blanket or mattress pad –
place primary control (label on back of control)
on the right side of the bed.
run cord
under the bed
Mattress Pad
Cord Connector
Secondary
Control
Primary
Control
Flag Tag
Label
Power
Cord
Module
Left Side
Right Side
1
3
4
5
2
3
Heated Blanket and Mattress Pad Set Up
CAUTION: Do not plug main power cord into the wall outlet until you have completely
set up your warming product per the instructions.
•
Disconnect power cor
d from wall before detaching control from warming product.
• Always make sure cords are NOT trapped or pinched between bed slats, mattress,
springs, against wall, foot board or bed frame, or between furniture, walls or chairs.
CAUTION: Do not attempt to force the plug. This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an outlet. If the
plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
IMPORTANT
run cord
under the bed
Blanket Cord Connector
Primary
Control
Flag Tag
Label
Power
Cord
Module
Left Side
Right Side
2
1
3
4
5
2
See Control Features on page 4
for your individual control.
If there is a flashing light or
your control displays a flashing
“FF”, see page 8.
For questions or support, please visit: www.sunbeam.com
• Single Control for heated blanket or mattress pad –
the control can be placed on either side of the bed.
5 Plug power cord into a 110-120 volt wall outlet.