Filter
Top Products
s/
_ PRE-FILTER
Figure 12
Figure 13
/
ELECTRONIC
COLLECTING
CONTACTS
Figure 14
TO REPLACE CABINET TOP
Replace the cabinet top by positioning over the unit.
(Figure 15) Gently slide top forward until the top drops
into place. (Figure 16) Slide top backward until flush
with the back of the unit. (Figure 17)
Operate the unit in “FAN ONLY” position for a min-
imum of one hour to insure the cell is thoroughly dry.
NOTE: An occasional “arcing” sound is normal when
operating the unit immediately after cleaning
the Cell and should stop after a few minutes of
operation. If cleaning the Cell does not alleviate
excessive arcing, refer to the Troubleshooting
Section on
page 5.
Figure 15
\\\\
Figure 16
Figure 17
4