Filter
Top Products
USING THE HOB
TROUBLESHOOTING
The hob produces a smell the rst
few times it is used.
Heat a pan full of water on each zone for
half an hour.
Pans make a noise during cooking
This is caused by vibration due to the pas-
sage of energy from the hob to the pan.
On a high setting this is quite normal for
certain types of saucepan. It will not dam-
age the hob.
The hob makes a slight clicking
sound
This is caused by the distribution of power
between two heating zones on the same
side of the hob.
Hob Status
Codes
Hob Status Description Action
L Cannotoperatehob(L)displayedbycontrol Child lock has been activated, deactivatie child lock
No Power Boost
Allow appliance to cool, power boost will be avail-
able when the appliance is cool.
ER21 Hob cuts off after programme setting The appliances has overheated allow to cool.
U400 Appliancenotworking(Cableconnectionfault)
Check mains cable connection & terminal at the
terminal block are wired correctly
E2 Inductioncoiloverheating(hotpan) Remove pans and allow to cool
E8 Fan blocked to appliance
Checkinstallationallowsforfreeairow,cleanfan
inlets at the rear/underside of the appliance.
The fan keeps working for a few
minutes after the hob has been
turned off.
This cools down the electronics.
The hob won’t work. The indicators
don’t come on
The electricity supply is not reaching the
appliance(faultysupplyorconnection);
Check the fuses and the cut-out switch.
Refer to Troubleshooting chart and if
problems persist call, the customer ser-
vice hot line for further assistance.