Filter
Top Products
INSTALLATION
13.300
Stone (Granite or equivalent)
worktops
Depending on the type of worktop
being used, there may or may not be
any backing material to screw the
clamp screws into.
1. If the worktop is a composite type
(backed with MDF or similar) there
may be enough backing to screw
directly into. This will depend on
the worktop thickness and backing
thickness and will have to be
assessed at the installation. In this
case, install the hob as for a standard
worktop.
2.Ifthereisinsufcientbackingmaterial
to screw into, or if the worktop
is completely solid in construction,
then it will be necessary to glue a
stripofwood,MDF,breboardor
similar to the underside of the worktop,
along the front and rear edges
of the cutout. Use a strong, proprietary
adhesive to bond these strips
and allow to cure before attempting
to clamp the hob into position.