Filter
Top Products
INSTALLATION
13.300
Important Information
It is important when installing front
control gas hobs, that the work top
cut out is the same as is quoted in
this installation manual. If the cut out
istoolarge,thenbatonsmustbetted
to the front, rear and sides - to
correct the discrepancy and ensure
thecorrectt.Pleaseensurethatif
batonsarettedtheyarelevelwith
the top surface of the work top
Please ensure that the seal for the
hob has full contact with the work
top surface.
There are two ways to install
the clamps, depending on the thickness
of the work top, please measure
the thickness of your work top and
ensure that the correct method is
used. Both methods are detailed in
the installation manual.
Failure to follow these instructions can
lead to exessive force being applied
to the basetray, which results in the
clearence between the control knob
and the hob top pressing being
reduced. This can effect the operation
of the gas control, and the ignition.
Base Tray
GDHA specified dimensions with batons
Existing dimension without batons