Filter
Top Products
INSTALLATION
between hob base and appliance must be
maintained.
Installation above an oven
Refer to the manufacturer’s instructions
for clearances above the oven.
We recommend a 25mm gap between the
bottom of the hob and appliance.
Installation above a unit with a
drawer or door
The base of the appliance must be pro-
tected from damage e.g. draws may only
be installed providing a partition panel is
ttedtotherequireddimensionsunder-
neath the appliance.
Worktop
25mm
Oven
Hob
INSTALLATION ABOVE AN OVEN
Worktop
25mm
Partician
Hob
Partition
INSTALLATION ABOVE A UNIT WITH
A DRAWER OR DOOR
General information
Installation should only be carried out by
aqualiedinstallerorengineer.
Please keep to the following points most
carefully;
Although every care has been taken to
ensure this appliance has no burrs, or
sharp edges, we recommend that you
wear protective gloves when install-
ing and moving this appliance. This will
prevent injury.
The minimum distances to other appli-
ances and units are to be observed.
Wall surfaces above the work surface and
in the immediate vicinity of the cooking
hob must be heat resistant.
Laminated surfaces and the adhesive
usedforxingthemmustbeheatresis-
tant in order to avoid any damage.
The space for air circulation, located
underneath and at the back of the hob
improves its reliability by ensuring that it
willcooldown,efciently.
Installations should be carried out in line
with the National Regulations applicable
with this product type.
Note: Avoid installing the appliance next
to doors and under windows. This will
avoid the potential for hot cookware
being knocked off the hob when doors
and windows are opened (Risk of burns).
Built-in appliances may only be used after
they have been built-into suitable built-in
units and surfaces that meet the required
standards.
CHOOSING YOUR INSTALLATION
We recommend that you install this ap-
pliance in a work top which is a minimum
38mm deep.
Thehobcanbettedintoaworktop
less than 38mm deep, but the 25mm gap