Filter
Top Products
Cabinet Series Dehumidifying Dryer 30
8. Press the WRITE key (#6) to store the correct time.
9. The time and day can be adjusted or changed while the timer is operating.
Daily Timer Operation
Daily time is typically set to operate from 8:00 AM and to stop at 5:00 PM from Monday through Friday.
1. Set the MODE switch (#11) to P1.
2. Press the SHIFT key (#1) to move the cursor to the desired day of the week. Or select several
days at once by using the SHIFT (#1) and SET keys (#2). The bar mark will turn on under the
chosen days.
3. Press the SET key (#2).
4. Set the desired start time by pressing the h key (#3) to adjust the hour. Holding this key will
rapidly advance the hour.
5. Press the m key (#4) to adjust the minutes.
6. Press the WRITE key (#6) to store the start time in the timer memory.
7. Next, set the stop time by using the h and m keys, then press WRITE.
8. Turn the MODE switch (#11) to run.
Multiple-Day Operation
Multiple day operation will start the dryer on one day and run continuously for several days before
stopping the dryer.
1. Turn the MODE switch (#11) to P1.
2. Select the desired start day with the SHIFT (#1) and SET keys (#2).
3. Set the start time with the h and m keys.
4. Press the WRITE key (#6) to store the dryer startup hour in the timer memory.
5. Next cancel the day that was just set by using the RESET key (#2).
6. Now select the stop day by using the SHIFT (#1) and SET key (#2).
7. Set the stop time with the h and m keys.
8. Press the WRITE key (#6).
9. Turn the MODE switch (#11) to RUN.
Checking the Set Time
The set times can be checked in the sequence the timer is to operate.
1. Press the CHECK key (#5). Each time the key is pressed the operation schedule is displayed in
the time sequence.
2. If the time switch is left untouched for 20 seconds during check, the display automatically returns
to RUN mode.
If a holiday occurs during the weekly operation, the off time for Sunday can be executed for the holidays.
The override will execute for one week only, then the timer will automatically go back to the previous
program.