Filter
Top Products
Chapter 3: Installation 14 of 41
3-2 Installing the Granulator
NOTE: Before lifting or moving the granulator, check the relative weight shown on the
shipping papers.
To facilitate the lifting operation using forklift trucks, the drop box has been removed
from the granulator and is packed with any spare parts.
When using a forklift to move the granulator, make sure it is suitable for the weight and
dimensions of the granulator. When moving the machine, make sure NOT to damage
delicate parts. To lift the machine with a forklift, place the carriage forks under its base
(see below figures). When a forklift truck is not available, it is possible to use cables or
belts provided that they are strong enough to support the weight of the granulator to carry
out the lifting procedure.
NOTE: When moving the granulator, the load must remain I the horizontal position,
regardless of the type of equipment used.
Positioning the Granulator
NOTE: Make sure that the base supporting the granulator is solid and completely level
the granulator can be supported without being subject to vibration. It is recommended
that the floor be reinforced concrete with a very smooth surface.
Place the granulator in an area large enough to allow sufficient space on all sides
for the operator to carry out maintenance.
Although the granulator controls and electrical components comply with CEE
and NEMA codes and regulations, the machine must be placed in an area free of
humidity, dampness, and water. The proper environment for a granulator is a
weather-proof, covered, in-door area where water cannot collect on the floor.
Once the granulator is in position, the front panel must be opened I order to insert
the bin as shown in the figure below.