Filter
Top Products
4
4
Width of firebox
Sonoran 36 45”
Sonoran 42 51”
Sonoran 48 57”
“A” see above
CAUTION: All gas piping and connections must be tested for leaks-before the installation is completed. After ensuring that
the gas valve is on, apply a soap and water solution to all connections and joints. If bubbles appear, leaks can be detected
and corrected. DO NOT USE AN OPEN FLAME FOR LEAK TESTING AND DO NOT OPERATE ANY APPLIANCE IF A
LEAK IS DETECTED.
CLEARANCES
MINIMUM CLEARANCES TO COMBUSTIBLES ARE:
Enclosure:
0" from side of unit to framing
2" from top of unit to combustables
0.5" from back of unit to combustables
In front:
5" from fireplace opening to side wall
12" from Fireplace opening to Mantel
7" from fireplace opening to Top Trim
3" from fireplace opening to side trim
Floor:
No thermal protection required
- Floor in front flush to fireplace opening
- 0" to combustable Floor under unit
Part Preparation
Inspect all parts & using scraper or painter’s tool, clean part corners edges if needed. Make sure all mating surfaces are
clean and free of excess dust & debris. Using 4” brush or a spray bottle, thoroughly moisten all bond surfaces.
THIS MUST BE DONE TO ENSURE PROPER ADHESION OF COMPONENTS AND SEALING OF JOINTS
IF ANY PARTS ARE DAMAGED DO NOT INSTALL CONTACT DEALER FOR REPLACEMENT
FIREBOX
A. BASE PEDESTAL PREPARATION
Make sure floor is level
B. . CENTER SECTION INSTALLATION (2 PARTS)
The center back wall consists of 2 sections assembled against each other.
DO NOT BOND FRONT & REAR SECTIONS TO EACH OTHER.
Apply a 3” wide X ¼” thick bed of refractory adhesive to base approximately 1”
in from edges of sides and back. (Where sides and back will sit.) Stand both
sections of back wall on base and support while applying adhesive to cover the
join line between front & rear sections. The coating of cement should cover the
seam all around the outer edges of the back wall. This coat should be smooth
but not excessive. (1/8” thick max.)
VFT
CL
Depth of firebox
Sonoran 36 24 ½”
Sonoran 42 24 ½”
Sonoran 48 24 ½”
“A” see above
36”- 52” from corner
42”- 65” from corner
48”- 70” from corner
36”- 73 1/2” - 42”- 91 1/2” - 48”- 99 1/2”
C-2 Parts
B
CR