Filter
Top Products
4
Step 2: Remove Stands from the TV
1 Place the 32” model (KZ-32TS1E) or 42” model (KZ-42TS1E) on 4 cushioned supports (not supplied).
The TV screen should face down, parallel to the floor and the base/stand should not touch the floor.
2 Pull the base/stand out from the TV.
For KZ-32TS1E
At the bottom of the rear panel of the TV, cut out the 4 rear panel caps (if there are any) with clippers and scrape the plastic clean with
reamers, so each opening is round and smooth enough to allow a screw to be removed.
For KZ-42TS1E
At the bottom of the stand of the TV, you will see the screws securing the stand. With a (Philips) magnetic screwdriver, remove all the
screws that secure the base to the TV.
3 For KZ-32TS1E only
Attach the covers (F, H) on the bottom of the TV.
KZ-32TS1E
How to remove the stand and assemble the
covers
KZ-42TS1E
How to remove the stand
1
Rear of TV
Remove the four
(4) caps from
the chassis (if
there are caps).
Stand
Cushioned
support
Remove the four (4)
screws.
Remove
stand and
store away.
2
Secure the two covers (H)
with M6 that was previously
removed from the TV stand.
Close rectangle
hole by cover
sheet (F).
3
Rear of TV
Remove
the eight
(8) screws.
Remove stand
and store away.
Cushioned
support
2
1