Filter
Top Products
28
GB
1 Press AUTO CAL.
Measurement starts in 5 seconds and the
display changes as follows:
A.CAL [5] t A.CAL [4] t A.CAL [3]
t A.CAL [2] t A.CAL [1]
While the time is counting down, stand
away from the measurement area to avoid
measurement error.
2 Measurement starts.
The measurement process will take a few
minutes to complete.
The table below shows the display when
measurement starts.
* The corresponding speaker indicator lights
up in the display during measurement.
3 Measurement ends.
“COMPLETE” appears on the display
and the settings are registered.
4 Disconnect the optimizer
microphone from the AUTO
CAL MIC jack.
Note
Auto Calibration cannot detect the sub woofer.
Therefore, all sub woofer settings will be
maintained.
Tip
During the measurement process, Auto Calibration
is canceled when you do the following.
– Press ?/1, input buttons or MUTING.
– Change the volume level.
– Press AUTO CAL again.
Performing Auto Calibration
123
46
78
0/10
ENTER
9
SYSTEM STANDBY
TV INPUT
SLEEP
DMPORT
TV
?/1
AV
?/1
VIDEO 1 VIDEO 2 VIDEO 3 DVD
2CH A.F.D.
RETURN/EXIT
MENU
MOVIE MUSIC
MEMORY DVD MENU
FM MODE
CLEAR
TOOLSDISPLAY
MUTING
TV VOL
MASTER VOL
AUTO CAL
D.TUNING
D.SKIP
AMP MENU
SAT TV SA-CD/CD TUNER
?/1
-
F
Gg
f
5
>10/
Input
buttons
?/1
switch
MUTING
MASTER
VOL +/–
1
Measurement for Display
Environment noise
level
NOISE.CHK
Speaker connection MEASURE and SP
DET. appears
alternately*
Speaker level MEASURE and GAIN
appears alternately*
Speaker distance MEASURE and
DISTANCE appears
alternately*