Moving the Dehumidifier
1. Drain the water.
2. Lift up the handle and tilt the unit back.
3. Move the unit by rolling on the back casters.
NOTE:
1. If the floor is made of a material that scratches easily, or if the floor is uneven, lift the unit off the floor
and move it. Avoid rolling the unit if the floor has shag carpeting. This can damage the surface of
the carpet.
2. Tilt it within range of 20 to 30 degrees. (If you tilt the unit too far, you may scratch the floor or water
may leak.)
3. Be careful that the power supply cord does not get pinched under the unit.
Clearance
Maintain the minimum clearance around
the dehumidifier when the unit is operating
as shown in the figure at right.
MAINTENANCE
Cleaning the Dehumidifier
To Clean the Body
Clean the body of the unit by wiping with a soft damp cloth. You may use a mild detergent if necessary.
• Gasoline benzene, thinners, scouring powder, chemically treated dust cloths, and detergents
may damage the main unit and should not be used.
To Clean the Air Filter
1. Remove the Air Filter
Grasp the filter panel at the top and pull towards you to remove.
2. Clean the Air Filter
Run a vacuum cleaner lightly over the surface of the filter to remove dirt. If the air filter is
exceptionally dirty, wash it with warm water and a mild cleanser. Dry thoroughly.
3. Replace the Air Filter
Insert the lower tabs of the air filer panel into the slots on the main unit and press into place
until you hear the tabs click into place.
9