Soleus Air SG-WAC-15ESE Air Conditioner User Manual


 
13
USING YOUR AIR CONDITIONER
Electronic Control Panel & Remote Control
1. Power Button: Turns the air conditioner on and
off
2. Digital Display:
Displays the current room tem-
perature or the amount of time left on the timer.
Shows the Set Temp when setting the tempera-
ture. Shows the Timer Set when setting the timer.
The once the timer and/or temperature are set,
the display will change to show the current room
temperature. To see the set temperature again,
simply press either of the Temp/Delay /
buttons.
3. Temperature Set:
Use these buttons on the con-
trol panel and remote to increase or decrease the
Set Temperature (the desired room temperature)
in cooling or energy saver mode. The SET light
will light up when setting the temperature
4. Timer Set:
Use these buttons on the control
panel and remote to set the Timer. Each press of
the Timer (DELAY) buttons will increase or de-
crease the timer. For timer instructions see #7.
5. Fan Speed & Auto Fan
: Use the fan speed but-
tons to change the fan speed. Choose between
low, medium, high, and Auto. When using the re-
mote control, press the AUTO button to turn auto
mode on and the FAN+ and FAN– buttons
to
select low, medium, or high fan speed.
6. Mode Button:
Press the mode button to cycle
through the various modes: Cooling, Energy
Saver, and Fan only.
7. Auto-on Timer:
When the air conditioner is off, it
can be set to automatically turn on in 1-24 hours
at the previous set mode and fan setting. To set
the Auto-on Timer, press the DELAY button on
the unit or remote control. Each touch of the /
on the unit or the +/- buttons on the remote will
change the timer setting in 1 hour intervals. The
SET light will turn on while setting.
Auto-off Timer:
When the air conditioner is on, it
can be set to automatically turn off in 1-24 hours.
To se the Auto-off Timer, press the DELAY button
on the unit or remote control. Each ouch of the /
on the unit or the +/- buttons on the remote will
change the timer setting in 1 hour intervals. The
SET light will turn on while setting.
To see the remaining time, press the DELAY
Button. To change the timer setting use the
/ on the unit or the +/- buttons on the
remote.
To cancel the timer, press the DELAY button
until the SET light turns off.
Air Conditioner Controls
Remote Control
This display always shows the room
temperature except when setting
the Set temperature or the Timer.
When the light is on the unit is in
temperature or timer set mode.
Light Indicates the
Timer is set.
Timer Increase
Auto Fan On
Increase Fan Speed
Power Button
1-24Hr Timer
Timer
Decrease
Mode Button
Decrease
Fan Speed
Increase/
Decrease
Temperature
Normal Operating Sounds
You may hear a pinging noise caused by water
hitting the condenser, on rainy days, or when the
humidity is high. This design feature helps re-
move moisture and improve efficiency.
You may hear the thermostat click when the com-
pressor cycles on and off.
Water will collect in the base pan during rain or
days of high humidity. The water may overflow
and drip from the outside part of the unit.
The fan may run even when the compressor is
not on.