Filter
Top Products
ASSEMBLY & INSTALLATION (CONT.)
7
3/4” Screws
Frame Lock
Sash Lock
7
2
1
MOUNTING HARDWARE
Qty
Tools Needed:
Phillips Screw Driver
Drill (if plot holes are needed)
Frame Lock, Sash Lock, and Foam Seal
Installation
1. Place the frame lock between the extended accordion
panels and the window sill as show in FIG. 8. Screw a
3/4” (19 mm) locking screw through the frame lock and
into the window sill (FIG. 9).
2. Drive 1/2” screws into the top of the accordion panel
frame and the top rail to securely attach the window air
conditioner to the lower sash. (See FIG. 11/12)
3. To secure the lower sash into place, use the sash lock
and a 3/4” screw as shown below (See FIG. 12)
4. For added insulation, cut the supplied insulation foam to
the width of the window. Insert the foam between the
window sashes to prevent air and objects from getting
into the room. (See FIG. 13)
Removing the Air Conditioner from the
Window
1. Turn the air conditioner off, and disconnect the power
cord.
2. Remove the sash seal from between windows, and
unscrew sash lock.
3. Remove the screws installed through the frame and
frame lock.
4. Close (slide) the side panels into frame.
5. Keeping a firm grip on air conditioner, raise the sash
and carefully “rock” air conditioner backward to drain
any condensate water in base of unit. Be careful not to
spill any remaining water while lifting unit from window.
6. Store parts WITH the air conditioner in the box
FIG. 13