Filter
Top Products
14
REMOTE CONTROL OPERATING INSTRUCTIONS
1) Power On and Off - Press the POWER (I/O) button once to manually turn the unit on. Press the Power
button once more to turn the unit off. When you press the POWER button the upper right square on the
remote control LED Display will light up. When in Air Conditioner and Auto mode, the selected tempera-
ture will appear on the remote control display. When the unit is in Fan mode and Dehumidifier mode you
will see the “- -” icon instead of the set temperature. This shows that temperature selection is not available
when the unit is in Fan or Dehumidifier mode.
2) Mode Selection - Press the MODE Button repeatedly to cycle between the different modes: Auto, Air
Conditioner, Dehumidifier, Fan only, and Heater mode. The upper left square on the Remote control dis-
play will light up showing which mode is selected. In Air Conditioner mode the display will show
“COOL”, in Heating mode the display will show “HEAT”, in Dehumidifier mode the display will show
“DRY”, in Fan mode the display will show “FAN”, and in Auto mode the display will show “AUTO”.
3) Fan Speed - Press the FAN speed button to cycle through high, medium, and low fan speeds. The dis-
play on the remote control will show HIGH, MED, & LOW under the “SPEED” label on the remote con-
trol LCD display. There is an additional auto speed setting that is enabled in only heating and cooling
modes. This speed is next setting after low when pressing the FAN speed button on the remote control.
The speeds will cycle through in this order: High, Medium, Low, Auto. Each change in speed will be as-
sociated with a “beep” sound from the unit. The remote control will not display “AUTO” under the speed
label. Once Auto fan speed is selected the unit will beep and there will not be a fan speed displayed on the
remote control.
4) Temperature Setting - When the unit is in Air Conditioner or Heating mode you can select your desired
temperature. Press the ▲ or ▼ to select your desired temperature setting. The temperature on the LCD dis-
play on the remote control will increase or decrease accordingly. Pressing the ▼and ▲ buttons simultane-
ously will change the temperature select between °F and °C.
5) SLEEP MODE - See “SLEEP MODE” on page 12.
6) SWING - To turn on oscillation, press the SWING button on the remote control. Once you press SWING
button, the louvers on the unit will oscillate up and down “ ” . To change the horizontal direction of the
air flow manually adjust the internal horizontal louvers left or right. Once SWING is selected the “ “
icon will show up on the LCD display on the remote control.
7) CLOCK
- To set the clock on the remote control, hold down either the MIN or HOUR button until the
displayed time flashes on the remote control display. Change the minutes by pressing the MIN button and
change the hours by pressing the HOUR button. Set the clock prior to programming the timer.
8) TIMER
- After setting the clock, you are ready to program the timer. program the timer, first press the T-
ON button when the unit is off. Once T-ON is pressed the auto-on timer will blink in the bottom right rec-
tangle of the remote control display. Press the MIN and HOUR buttons to change the clock to the desired
time for the unit to automatically turn on. The minutes will increase by 10 with each press of the MIN but-
ton and the hours will increase by 1 with each press of the HOUR button. Press the T-OFF button when
the unit is on to set the off timer. The remote control display will flash the desired auto-off timer. Press the
MIN and HOUR buttons to change the clock to the desired time for the unit to automatically turn off. The
timer is set when the auto-off time stops flashing and the words “ON” and “OFF” are displayed next to the
time.