Soleus Air PH5-13R-35D Air Conditioner User Manual


 
Heating Mode
1) Install the exhaust hose and window kit properly (see pages 7 & 8 ).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER button on the control panel.
4) Press the MODE button until the “ “ icon appears on the control panel display.
5) Press the or buttons until the desired room temperature appears on the control panel display. The
temperature ranges from 61
°
F - 88
°
F (16
°
C - 31
°
C).
6) Select the fan speed by pressing the FAN button. It is recommended to set the fan speed to low.
NOTE: When heat mode is selected, the unit will shut down for 3-5 minutes, then start in heating mode.
NOTE: When the unit is running on heating mode, the exhaust hose is required and must be
vented outside using the supplied window kit.
Dehumidifier Mode
1) Install the exhaust hose and window kit properly (see pages 7 & 8 ).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER Button on the control panel.
4) Press the MODE button until the “ ” appears on the control panel display.
NOTE: The unit operates at low fan speed during dehumidifier mode. The unit cools room slightly during
while dehumidifying. Keep the windows and doors closed to aid the effectiveness of the unit as it removes
moisture from the room.
NOTE: The unit will not perform in dehumidifier mode when the room temperature is lower than 61
°
F .
Fan Mode
1) Plug the Power Cord into an electrical outlet.
2) Turn on the unit by pressing the POWER button on the control panel.
3) Press the MODE button until the “ ” icon appears on the control panel display.
4) Select the fan speed by pressing the FAN button.
5) To circulate more air, press the SWING button on the remote control. (The louvers will oscillate up and
down )
NOTE: It is not necessary for the exhaust hose and window kit to be installed to operate the unit in fan mode.
Auto Mode
1) Install the exhaust hose and window kit properly (see pages 7 & 8 ).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER button on the control panel.
4) Press the MODE button until the “ ” icon appears on the control panel display. Select the fan speed
by pressing the FAN button.
NOTE: During AUTO mode, the unit operates in Dehumidifier mode when the room temperature is between
11