Filter
Top Products
10
OPERATING THE UNIT USING THE CONTROL PANEL
Air Conditioner Mode
1) Install the exhaust hose and window kit properly (see pages 7 & 8 ).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER button on the control panel.
4) Press the Mode button until the led of AIR CONDITIONER light up on the control panel display.
5) Press the ▲ or ▼ buttons until the desired room temperature appears on the control panel display. The
temperature ranges from 61
°
F - 88
°
F (16
°
C - 31
°
C).
6) Select the desired fan speed by pressing the FAN button.
NOTE: During hot days, the unit will cool the room most efficiently by setting the temperature at the lowest
setting and the fan speed on high. Reducing the length of the exhaust duct, insulating the exhaust hose and
window kit, and keeping direct sunlight to a minimum will also improve the cooling efficiency.
NOTE: When the unit is running on cooling mode, the exhaust hose is required and must be vented outside
using the supplied window kit.
Dehumidifier Mode
1) Install the exhaust hose and window kit properly (see pages 7 & 8 ).
2) Plug the Power Cord into an electrical outlet.
3) Turn on the unit by pressing the POWER Button on the control panel.
4) Press the MODE button until the led of DEHUMIDIFIER light up on the control panel display.
5) change the direction of the air flow manually adjust the horizontal louvers up or down.
NOTE: The unit operates at low fan speed during dehumidifier mode. The unit cools room slightly during
while dehumidifying. Keep the windows and doors closed to aid the effectiveness of the unit as it removes
moisture from the room.
NOTE: When the unit is running on dehumidifier mode, the exhaust hose is required and must be vented
outside using the supplied window kit. The unit will not perform in dehumidifier mode when the room tem-
perature is lower than 61
°
F .
Compressor Indicator
The COMPRESSOR LED will light up on the control panel display when the compressor turns on. The LED of
COMPRESSOR will turn off when the compressor shuts off.