Soleus Air KFTHP-24-ID Air Conditioner User Manual


 
15
Installation Instructions
Piping Joints Thermal Insulation:
Wrap the piping joints with thermal
insulation materials and then wrap
with a vinyl tape.
Piping Thermal Insulation:
a. Place the drain hose under the piping.
b. Insulation material uses polythene foam over in thickness.
Note: Drain hose is prepared by user.
3/8"
Drain pipe should point downward for easy drain flow.
Do not arrange the drain pipe twisted, sticking out or wave
around, do not immerse the end of it in water.
If an extension drain hose is connected to the drain pipe, make
sure to thermal insulated when passing along the indoor unit.
When the piping is directed to the right, piping, power
Cord and drain pipe should be thermal insulated and
fixed onto the back of the unit with a piping .connector
Thermal insulation
wrapped with vinyl type
Small
pipe
Large pipe
Thermal insulation
tube
Power cord 1
(for heat-pump)
Power cord
Defrost cable(for heat-pump)
Drain hose
(prepared by user)
A. Insert the pipe to the slot.connector
B. Press to hook the pipe onto the base.connector
Base
Base
Base
Piping connector
Piping fixer
Hook here
Insert here
drain
hose
drain
hose
large
pipe
large
pipe
small
pipe
small
pipe
11
NOTENOTE
The temperature of refrigerant circuit
will be high, please keep the
interconnection able away from the copper tube.c
Refrigerant Line Connection Torque Table
Flare Nut
Tightening Torque
1/4-3/8 "
1/4-1/2 "
1/2-3/4 "
7/8-1
1/8"
25 Ft.LBs(350 Kg.Cm)
40 Ft.LBs(560 Kg.Cm)
60 Ft.LBs(840 Kg.Cm)
110 Ft.LBs(1540 Kg.Cm)
Tighten flares to below torques:
Connecting the refrigerant lines between the indoor& outdoor units
Note that since the refrigerant metering device is located in the outdoor unit,both refrigerant
lines must be insulated with a minimum of 3/8 foam along the entire length.
Gently bend the line set stubs from the indoor unit to the desired location and the using 2 box
end or adjustable wrenches,remove the flare nuts from the indoor unit line stubs.The indoor
unit is charged with a dry gas.If you do not hear the release of pressure when removing the
flare nuts,it is possible that the evaporator section(indoor unit)has developed a leak and you
should contact your dealer for a replacement indoor unit.Note:Using a small amount of
vacuum pump oil on the male flare threads will ease installation.Snug the line set to the stubs
using the 2 wrenches-one wrench on the male fitting and one wrench on the female fitting.
"