Filter
Top Products
Installation Operation
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER !
Required tools for use on floor:
phillips screwdriver
(not included)
Required tools for wall
mounting:
phillips screwdriver
(not included)
drill (not included)
hammer (not included)
A. On the floor
Insert the feet and bolts onto the
unit as shown in the diagram
.
B. On the wall
STEP 1
Using the mounting support as a
guide, mark the first screw hole
on the wall.
STEP 2
Drill first hole.
STEP 3
Insert first screw anchor into the
first hole.
STEP 4
Put mounting support on the wall
and tighten it lightly.
STEP 5
Mark second screw hole on the
wall [approximately 5 7/16 in.].
STEP 6
Drill second hole.
STEP 7
Insert second screw anchor into
the second hole.
STEP 8
Tighten both screws.
1. Ensure that the Temperature
Control Knob is at “DOT”
position. [Fig 1]
Also, make sure the power
switch is at the off position.
[Fig 2]
2. Plug the power cord into a
suitable electrical outlet.
[Rated not less than 115 volt]
3. Turn the power switch to the
“ON” position, then adjust the
Temperature Control Knob
clockwise until the Red Light
Indicator turns on [Fig 2]. At this
moment, the Temperature
Control will start working.
Note: The Red Light Indicator
will turn off when the room
reaches the desired temperature.
After a while, as the room
temperature falls, the heater will
turn on again and release heat
until the room temperature rises
to the desired temperature.
Desired room temperature is
maintained automatically by this
procedure.
You can adjust the temperature
control knob to increase or
decrease the room temperature as
desired by turning in a clockwise
or counter-clockwise direction as
shown in the figure.