Filter
Top Products
Assembly Operation
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER!
Required tools:
phillips screwdriver
(not included)
Align the foot bases with the
bottom of the unit. Use the
included bolts to attach the foot
bases to the heater body as
shown in the diagram.
1. Ensure that the Temperature
Control Knob is at “OFF”
position. [Fig 1]
2. Plug the power cord into a
suitable electrical outlet.
[Rated not less than 115 volt]
3. Turn the Temperature Control
Knob clockwise until the Light
Indicator turns on [Fig 2]. At this
moment, the Temperature
Control will start working.
Note: The Light Indicator will
turn off when the room reaches
the desired temperature. After a
while, as the room temperature
falls, the heater will turn on
again and release heat until the
room temperature rises to the
desired temperature. Desired
room temperature is maintained
automatically by this procedure.
You can adjust the temperature
control knob to increase or
decrease the room temperature as
desired by turning in a clockwise
or counter-clockwise direction as
shown in the figure.