Soleus Air FSM-45 Fan User Manual


 
This product employs overload protection (fuse). A blown fuse indicates an overload or
short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the
fuse per the instructions below and check the product. If the replacement fuse blows, a
short-circuit may be present and the product should be discarded or returned to an
authorized service facility for examination and/or repair.
HOW TO REPLACE THE FUSE
1. Unplug the fan from the outlet. Place the plug on a firm, flat
surface. Open the fuse cover, located on the top of the plug,
using your thumb or a flathead screwdriver to slide the over
towards the prongs.
NOTE: Ensure that the fuse cover is completely open before
attempting to remove the fuse.
2. Remove the fuse carefully by using a small screwdriver to pry
the fuse out of the compartment by the metal ends of the fuse.
3. Risk of fire. Insert a new 2.5 Amp, 125 Volt fuse (provided
with product) into the fuse compartment, making sure that the
fuse is securely in place.
4. Slide the fuse cover closed completely. If the fuse cover is
difficult to close, make sure the fuse is properly secured in
place by pressing down on the metal ends of the fuse.
CAUTION: Risk of fire. Do not replace the attachment plug. It
contains a safety device (fuse) that should not be removed. Do not use the product if
the attachment plug is damaged.
To avoid a risk of fire, only replace with a 5 Amp, 125 Volt fuse (provided with the
product). To order a new fuse, contact SI Products Service at (888) 856-6781
4