Filter
Top Products
feature! The user cannot control the machine with vertical handle.
After switching on the machine, the handle will move shortly to the right.
Lifting or lowering the grip controls the direction, in which the machine moves.
The more you lift or lower the grip, the faster the machine runs to the
corresponding direction.
- lifting the grip: machine runs to the right
- lowering the grip: Machine runs to the left
If you feel unsafe or cannot control the machine just release lever (4). The
machine will stop at once. If you have carried out some training, you will be able
to operate the machine with one hand.
Always remove discs or brushes after work. Remove also the cleaning tank, if one
has been used. Always disconnect the power cord after work or when leaving the
machine.
Operation with vacuum cleaner
Note: the vacuum cleaner cannot – on technical grounds – remove the grinding
dust from under the discs. It will always remove the fine dust. To clean the floor,
use an industrial cylinder vacuum cleaner.
5.1 Operation with cleaning tank
Assemble the cleaning tank with 2 supports to the
handle.
5
- insert lower connector into the plastic
mounting
- lock the upper connector by shifting the
upper plastic mounting down
Loosening the screws can shift the upper plastic
mounting.
Connect the chain (1) on top of the tank with lever
(2). Connect the tube (3) of the tank with one of
the 2 openings (4) on the right or left side of the
machine. By pulling lever (2), detergent liquid
pours onto the cleaning discs or brushes.
For cleaning works with grinding machine you
will the following accessories:
- mounting disc for pads, Item-No.
526270
- pads
- brushes
For initial cleaning, maintenance or polishing
various pads are available.