Filter
Top Products
12
Fig. 1
Fig. 2
Replacing the Vacuum Belt
WARNING! To Reduce the Risk of Electrical Shock
or Injury from Moving Parts, Turn the Vacuum Off
and Unplug the Charger from the Charge Point
Before Servicing or Cleaning the Vacuum.
NOTE: To ensure maximum cleaning efficiency,
the belt should be checked regularly to be sure
it is in good condition. Check to see if the belt
is stretched, cracked, or if excessive slipping is
occurring. Replace if needed.
• Turn the vacuum off and unplug the charger from
the Charge Point before changing the belt.
• Remove the battery (see see Removing and
Reinstalling the Battery, page 10).
• Remove the bottom plate (see Removing and
Reinstalling the Bottom Plate, page 11).
• Remove the brushroll and the worn or broken belt
from the brushroll pulley and the motor drive shaft.
• Loop the new belt around the motor drive shaft
and the brushroll (Fig. 1).
• Reinstall the brushroll into the nozzle. Turn
the brushroll by hand, making sure the belt is
not twisted and all rotating parts move smoothly
(Fig. 2).
• Reinstall the bottom plate (see Removing and
Reinstalling the Bottom Plate, page 11).
• Replace the battery (see see Removing and
Reinstalling the Battery, page 10).
MAIntenAnCe AnD CARe
MATERIAL
DRAWN
ISSUED
SCALE
FINISH
DATE
DATE
DO NOT SCALE
UNLESS OTHERWISE SPECIFIED
DESCRIPTION
DRAWING SIZE:C
PART NUMBER
SHEET 8 OF 8
TACONY CORPORATION CLAIMS PROPRIETARY
RIGHTS IN THE MATERIAL DISCLOSED HERE IN.
THIS DRAWING IS ISSUED FOR ENGINEERING
INFORMATION ONLY. IT MAY NOT BE REPRO-
DUCED, NOR MAY THE INFORMATION HERE IN
BE USED FOR MANUFACTURING PURPOSES
WITHOUT WRITTEN PERMISSION FROM TACONY
CORPORATION.
0.250
TACONY CORPORATION
1760 Gilsinn Lane, Fenton, MO 63026
DESCRIPTION OF CHANGE
REV
PART NUMBER
SHEET
8 OF 8
X.X .5 mm RADII X.X .5mm
X.XX .25mm X.XX .25mm
X.XXX .12mm MACHINE SURFACE
X.XXXX .012mm BREAK SHARP CORNERS TO .25mm MAX
0 30" COMMON TO BE CONCETRIC TO .05mm
BYECN NODATEREV
SCALE 0.400
SCALE 0.400
MATERIAL
DRAWN
ISSUED
SCALE
FINISH
DATE
DATE
DO NOT SCALE
UNLESS OTHERWISE SPECIFIED
DESCRIPTION
DRAWING SIZE:C
PART NUMBER
SHEET 8 OF 8
TACONY CORPORATION CLAIMS PROPRIETARY
RIGHTS IN THE MATERIAL DISCLOSED HERE IN.
THIS DRAWING IS ISSUED FOR ENGINEERING
INFORMATION ONLY. IT MAY NOT BE REPRO-
DUCED, NOR MAY THE INFORMATION HERE IN
BE USED FOR MANUFACTURING PURPOSES
WITHOUT WRITTEN PERMISSION FROM TACONY
CORPORATION.
0.250
TACONY CORPORATION
1760 Gilsinn Lane, Fenton, MO 63026
DESCRIPTION OF CHANGE
REV
PART NUMBER
SHEET
8 OF 8
X.X .5 mm RADII X.X .5mm
X.XX .25mm X.XX .25mm
X.XXX .12mm MACHINE SURFACE
X.XXXX .012mm BREAK SHARP CORNERS TO .25mm MAX
030" COMMON TO BE CONCETRIC TO .05mm
BYECN NODATEREV
SCALE 0.400
SCALE 0.400