Filter
Top Products
20
Maintenance and Care
When to change filters
The filters on your Synergy vacuum should
be replaced after 25 hours of operation.
The Synergy is equipped with a filter clock
to monitor the actual hours of operation
and will illuminate the change filter indicator
light on the nozzle of your vacuum when 25
hours of operation have elapsed.
When the filters are replaced, reset the
filter clock (while the vacuum is running) by
removing cap and pressing the reset button
when replacing filter. The change filter
indicator light will once again only illuminate
after the next 25 hours of operation.
Replacing the HEPA exhaust filter
Note: Your vacuum is equipped with either
the standard S-Class HEPA filter or the
S-Class HEPA Plus filter. To avoid confusion
when purchasing your filter, the item
number is located on the side of the filter.
Please give this number to your Authorized
Simplicity Retailer when purchasing filters
or bring your filter holder with you when
purchasing new filters.
• Access the filter by pressing down on the
release button located on top of the filter
holder.
• Remove the used filter and replace with a
new filter. Note: S-Class HEPA filters
cannot be washed and re-used.