Filter
Top Products
19
Maintenance and Care
When to Change the Filters
The lters on your Synergy vacuum should
be replaced after 25 hours of operation.
The Synergy is equipped with a lter clock
to monitor the actual hours of operation
and will illuminate the change lter indicator
light on the nozzle of your vacuum when 25
hours of operation have elapsed.
Note: When the lters are replaced, reset the
lter clock (while the vacuum is running) by
removing the cap located above the direct air
motor lter and pressing the reset button. The
change lter indicator light will once again only
illuminate after the next 25 hours of operation.
Replacing the HEPA Media Exhaust Filter
Note: Your vacuum is equipped with either
the standard HEPA media lter or the
HEPA media Plus lter. To avoid confusion
when purchasing your lter, the item
number is located on the side of the lter.
Please give this number to your Authorized
Simplicity Retailer when purchasing lters
or bring your lter holder with you when
purchasing new lters.
• Access the lter by pressing down on the
release button located on top of the lter
holder.
• Remove the used lter and replace with
a new lter. Note: HEPA media filters
cannot be washed and reused.