Sharper Image EVSI-HTR70 Electric Heater User Manual


  Open as PDF
of 6
 
10
Using the Remote Control
Battery Installation
One CR2032 3V battery is included with the remote control. To activate the remote
control functions, pull out the plastic pull tab protruding from the remote control
housing. To change the battery, remove the battery drawer at the bottom back
oftheremotebysqueezingthesideandpullingthedrawerout.Pleaseinsertthe
battery into the remote with the positive side up as shown on the drawer.
NOTE: Always keep the battery and remote control out of the reach of children.
Remote Control Features
•OnlyuseCR20323Vbatterywiththisremotecontrol.
•Donotmixoldandnewbatteries.
•Donotmixalkaline,standard(carbon-zinc),orrechargeable
(ni-cad, ni-mh, etc) batteries.
•Batteriesmayposeachokinghazard.Donotletchildrenhandlebatteries.
•Cleanthebatterycontactsandalsothoseofthedevicepriortobatteryinstallation.
•Afteropeningbatterydoor,besurethedoorisproperlyclosedandclicksshut.
•Removeusedbatteriespromptly.Disposeofusedbatteriesimmediately.
•Iftheunitisnotgoingtobeusedforalongperiodoftime,removebatteriesto
prevent damage due to possible battery leakage.
•Pleasedisposeofusedbatteriesperlocalregulations.
+
CR2032
PRESS
PULL
3V
Bottom of Remote
PowerON/OFF
Heat Settings
OscillationON/OFF
Timer Settings
11
Cleaning and Storage
We recommend that the heater be cleaned at least once a month and before
off-season storage.
• TurntheheaterOFFatthemainswitchandunplugit.Allowittocool.
• Useadryclothtocleantheexternalsurfacesoftheheater.
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION
• Cleanyourheaterusingtheabove-mentionedsteps,thendisassembleand
pack the heater in its original container and store it in a cool, dry place.
• Themotorisfactorylubricatedandwillrequirenofurtherlubrication.
Air Filter
• Dirtanddustmaybecaughtontheairlter,affectingthefunctionofthedevice.
Cleantheairlterregularly.
• Toclean,turnunitOFFandunplugunitfromoutlet,thenremovetheBackGrill
Coveronthebackoftheheater.Removetheairlterfromthegrill.
• Washthelterbyhandinalukewarmsolutionofwateranddetergent.Rinsethe
lterincleanwaterandallowittodrythoroughly.Placetheclean,drylterback
into the back grill and close the back grill cover.
• Donotusethedevicewithoutthelterandbackgrillcoversecure.
Troubleshooting
If the Heater Fails to Operate
• BesureitispluggedinandthattheACoutletisworking.Checkcircuitbreaker
in case of a blown circuit.
• Checkforanyobstruction.Ifyoundanobstruction,pressON/OFFmainswitch
to turn the heater OFF. Unplug the heater and wait at least ten minutes for it to
cool. Carefully remove the obstruction. Plug the heater back in and restart it as
described under OPERATING INSTRUCTIONS.
• Iftheheaterstilldoesnotoperate,removethepowercordfromtheACoutlet
and have the heater service by authorized SI product service personnel.
 previous