Filter
Top Products
ENGLISH
E-9
Plasmacluster ON/OFF Button
Press the Plasmacluster ON/OFF Button to turn Plasmacluster Ion
Mode ON and OFF.
When Plasmacluster is ON, both the Indicator Light and Plasmaclus-
ter Indicator will turn on.
LIGHTS CONTROL Button
Use when the the Plasmacluster
Indicator Light and CLEAN-SIGN Light
are too bright.
Refer to the diagram on the right to
select the desired brightness of the
Plasm aclus ter Indicat or Light and
CLEAN-SIGN Light.
ADJUSTMENT OF SENSOR DETECTION SENSITIVITY
Set to “low” if CLEAN-SIGN Light is constantly red to reduce sensitivity, and set to
“high” if CLEAN-SIGN Light is constantly green to increase sensitivity.
1
With the unit OFF, press the Fan Speed Button for 3 seconds.
The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The
factory setting is Standard, indicated by the MED light.
2
3
Press the Fan Speed Button to set
the desired sensor sensitivity.
Refer to the diagram on the right to select the
desired sensor sensitivity level.
Press the Power ON/OFF Button.
Note that if the Power ON/OFF Button is not pushed within 8 seconds of adjusting sensor sensitivity, the set-
ting will be saved automatically. The sensor sensitivity setting will be saved even if the unit is unplugged
.
Sensor Detection
sensitivity
Fan Speed
Indicator Light
High
Standard
Low
Plasmacluster Indicator Light
CLEAN - SIGN Light
Plasmacluster
ON/OFF Button
FAN SPEED Button
ION SHOWER Mode Button
POWER ON/OFF Button
LIGHT CONTROL Button
FAN Speed Indicator Lights
The lights are brighter.
The lights are darker.
The lights turn off
CAUTION
The lights on the front monitor are always brighter when starting.
W53E.eng.indd 11 08.11.13 3:11:29 PM