Filter
Top Products
ENGLISH
FRANÇAIS
ESPAÑOL
E-13
DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the condi-
tions of the air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash in
green, orange and red.
PLASMACLUSTER INDICATOR LIGHT
Plasmacluster ion operation is selected using the remote control.
Blue light
When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode and the air
in the room is impure, the Plasmacluster ions will be released continuosly.
Green light
When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster Ion Mode
and the air in the room is clean, this light will be activated and the unit will operate in Ion Control Mode.
Light off
There are no Plasmacluster ions being generated.
• The light can be turned off by using the ‘LIGHTS ON/OFF Button’ on the Remote Control. In this case,
Plasmacluster ions are generated.
(Please turn off the light if desired.)
CLEAN-SIGN LIGHT
CLEAN FILTER INDICATOR LIGHT
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the room air condition detected by the Odor Sensor
when the plug is inserted into the wall outlet.
• It is possible to have a green CLEAN-SIGN with impurities in the air at the time that the air purifier was
just introduced to the room environment. After a while, however, the base impurity rate will be adjusted
to detect room air condition correctly.
• Use the Lights ON/OFF Button on the remote control to turn off the Indicator lights if desired.
Clean (Green) Slightly Impure (Orange) Very Impure (Red)
Clean the Pre-Filter and the Active Carbon Filter when the CLEAN FILTER Indicator Light is on.
(The indicator light will be activated in about 2 months, when using the unit for 24 hours a day.)
(See Page E-16)
The color changes according to the air condition.