Filter
Top Products
Plasmacluster
AUTO
MANUAL
Fan Control
POLLEN
OFF
TIMER
QUICK AUTO
POWER ON/OFF
CLEAN
ION CONTROL
OFF
AUTO
Plasmacluster Ion mode Selections
Auto
When pressed, the unit will switch between
Clean Mode and the Ion Control Mode auto-
matically depending on the amount of impuri-
ties in the air as detected by the odor sensor.
Clean Mode will operate for 1 minute when
the Auto function is selected.
Ion Control
When pressed, the unit will constantly oper-
ate in Ion Control Mode.
The Plasmacluster Ion Indicator Light is green.
Clean
When pressed, the unit will con-
stantly operate in the Clean Mode,
in which the same numbers of posi-
tive and negative ions are dis-
charged. The Plasmacluster Indica-
tor Light is blue.
Off
The generation of ions will cease
and the Plasmacluster Indicator
Light will go out.
E-14
REMOTE CONTROL OPERATION
OPERATION
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• QUICK AUTO
Plasmacluster Ion mode
selections
• AUTO
• CLEAN
• ION CONTROL
• OFF
•When you press the POWER ON/OFF Button, a short
beep will sound and operation will start in AUTO Mode.
Transmitter
Pollen Mode Operation
Button
See Page E-12
Off Timer Button
The set time switches every time
the button is pressed as shown
below.
1 hour 4 hours
Cancel 8 hours
• The indicator light shows the
remaining time.
POWER ON/OFF Button
To stop, press the POWER
ON/OFF Button again.
A long beep will sound and
operation will stop.
Auto (Fan Speed) Button
The fan speed switches au-
tomatically depending on the
amount of impurities in the air.
Manual (Fan Speed) Button
The fan speed can be
switched among Silent, Low,
and High settings.
Quick Auto Button
The operation mode is effec-
tive when quick removal of
impurities in the air is de-
sired.
Note: By manually selecting ei-
ther Ion Control or Clean
Mode, this will lock the unit
into the selected mode and
will not change to the other
even if room condition
changes.