Filter
Top Products
EN-4
Points to keep in mind when using your unit.
WARNINGS FOR USE
• Install the unit in accordance with the installation instructions in the latter section
of this manual.
• Do not modify any part of this product.
• Do not insert anything into any part of the unit.
• Ensure the power supply used has an appropriate voltage rating.
Only use a three-pin grounded electrical AC socket rated 125V, 60Hz, and 15 amps or
more.
Use of a power supply with an improper voltage rating can result in damage to the unit
and possibly re.
• Always use a fuse with the proper amp rating.
Do not, under any circumstances, use wire, pins or other objects in place of a proper
fuse.
• In the event of any abnormality with the unit (ex. a burning smell), turn it off imme
-
diately and disconnect the power supply and contact a Sharp authorized service
center.
WARNING FOR POWER SUPPLY CORD
• This unit uses a plug with a built-in fuse.
Read the precautions on the plug before using the unit.
•Alwaysconducta“PowerPlugCheck”beforeusetoconrmthepowerplugfunc
-
tions normally.
• This power plug must only be plugged into an appropriate wall socket. Do not use
in conjunction with any extension cords.
• Push the power plug securely into the socket and make sure it is not loose.
• Do not pull, deform, or modify the power supply cord, or immerse it in water.
Pulling or misuse of the power supply cord can result in damage to the unit and cause
electrical shock.
• A damaged power supply cord must be replaced with a new power supply cord
obtained from the product manufacturer and not repaired. Replacement must be
performed by manufacture's service agent in order to avoid a hazard.
Radio or TV Interference
If this room air conditioner should cause interference to radio or television reception, try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the room air conditioner and radio/TV receiver.
• Connect the room air conditioner into an outlet on a circuit different from that to which the
radio/TV receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
PRECAUTIONS
CV-2P10SC_en.indd 4 11.3.22 11:00:11 AM