Filter
Top Products
7
INSTALLATION INSTRUCTIONS
Closure assembly
(Left)
8
Jamb
(Left)
Top angle
Sill
1/2 inch (13mm)
Closure assembly
(Left)
Stool
Insert the closure assemblies on both
sides into the rails of the jamb.
Secure the cabinet to the window
stool with 2 screws (L=1", 25.4mm),
working from the inside of the cabinet.
Secure the top angle and the closure
assemblies to the window sash with 3
screws (L=1", 25.4mm).
Secure the closure assemblies to the
sill with 2 screws (L=1", 25.4mm).
(1)
9
Replace the front panel. Slip the ex-
haust lever through the opening
between the horizontal louver and the
front panel then, hook the cabinet top.
(1)
Window sash foam seal
(2)
(3)
10
Slide the chassis back into the cabinet.
Replace the 3 screws removed in
step 3 to the Front and side of the cabinet .
(1)
(2)
CAUTION:
(2)
Cut the window sash foam seal to the
proper length and seal the opening be-
tween the top of the inside window sash
and the outside window sash.
12
Horizontal
Louver
Front
Panel
Exhaust
Lever
Move the exhaust lever and the 3 ver-
tical louver levers thoroughly to the left
when replacing the front panel.Take
care not to damage the levers.
11
Vertical louver lever
Normal screw
Scratching screw for
grounding.
Screw the front cabinet on at the bottom
corners with 2 screws removed in step 2.
Serration