Filter
Top Products
5
No.
Accessories
Q'ty
Right closure assembly
Left closure assembly
Window sash foam seal
1
1
1
1. Screw driver (medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Cotton gloves
INSTALLATION INSTRUCTIONS
Screws(L=1", 25.4mm)
Top angle
7
1
9
Screws(L=
1
/
4
", 6mm)
Window sash foam seal
(adhesive type)
1
Battery
Remote control
2
1
Cut the window sash foam seal (adhesive type) to
the proper length and attach it to the underside of
the window sash.
1
WARNING: Make sure the unit is turned off and unplugged before working.
Wear cotton gloves when working on installation, in order to avoid injuries.
window sash foam seal
(adhesive type)
ITEMS PACKED WITH THIS UNIT
SUGGESTED TOOLS
INSTALLATION
1
2
3
4
5
6
7
8
9
5
Front panel
Exhaust Lever
(1)
2
Unscrew the 2 screws at the corners of
the front panel. Keep them as they will
be used later.
Remove the front panel by pulling the
front panel at the lower corners towards
you about an inch.
Next lift it up and pull it towards you.
(2)
Move the exhaust lever and the 3 ver-
tical louver levers thoroughly to the left
when replacing the front panel.Take
care not to damage the levers.
CAUTION:
Front
panel
Horizontal
Louver
Vertical louver lever