Filter
Top Products
13
CLOSED OPEN
EXHAUST Lever
ENERGY
SAVER
ENERGY
SAVER
HOW TO OPERATE
ENERGY SAVER
TO CHANGE AIR FLOW DIRECTION
During normal operation, the thermostat automatically controls cooling and the fan runs
continuously. When the ENERGY SAVER is selected, the thermostat automatically
controls cooling and the fan automatically stops when the compressor is not operating.
(Fan will stop 30 seconds
after the compressor stops.Even after the fan stops, the fan will
rotate for 2 minutes, every maximum 20 minutes, to detect room temperature.
)
Procedure
Pad
2
To cancel, touch
ENERGY SAVER
pad again.
• ENERGY SAVER indicator
will light.
• ENERGY SAVER indicator
will go off.
NOTE: ENERGY SAVER cannot be set during FAN ONLY mode operation.
Display / Indicator
During cooling operation
1
Touch ENERGY
SAVER pad.
Adjust the louvers to change the direction
of air flow for uniform and efficient cooling
of the room.
Vertical louvers
Adjusts LEFT/RIGHT air flow
If air in your room is stale, set the
EXHAUST lever to the OPEN position.
This will exhaust stale air to the outside.
The EXHAUST lever should normally
be kept in the CLOSED position during
cooling for maximum efficiency.
EXHAUST
Horizontal louvers
Adjusts UP/DOWN air flow