Filter
Top Products
4
TOLL FREE: 1-800-798-7398
5
www.sharkclean.com
English
IMPORTANT: Your hand steamer
needs water to make steam! Never
use your hand steamer without water
in the tank.
Remove any large debris from the
surface prior to cleaning with your
hand steamer.
Visit www.sharkclean.com for other
great steam cleaning products to
complement your hand steamer.
Using Your Hand Steamer
1 Plug into a 120-volt electrical
outlet (fig. 1). The “On” light will
turn blue. If the light does not turn
on, reference the troubleshooting
section on page 6.
2 Wait 30 seconds for the boiler to
heat the water. Pump the handle
a few times to prime the pump,
activate steam and moisten the
micro-fiber pad (fig. 2).
3 Pump the handle as you clean your
sealed surfaces to customize
steam output.
CARE OF YOUR MICRO-FIBER
CLEANING PAD & BONNET
1 Wash pads in warm water. Wash
separately from other laundry. Only
use liquid detergent (no powder
detergent). Do not use fabric
softeners. Line dry or dry on a low
dryer setting.
2 If there are loose threads on the
pad carefully cut the threads with
scissors. Do not pull on them or cut
at the base
IMPORTANT: The micro-fiber
cleaning pad may be very hot
from the steam. Use caution when
removing. Let the unit cool for
2-3 minutes.
Care of Your Hand Steamer
fig. 5fig. 3
fig. 4
fig. 2
AFTER USE AND STORAGE
1 When you have finished using the
Shark
®
Handheld Steam Scrubber,
unplug the cord from the outlet and
stand the hand steamer upright as
you would an iron. Let the unit cool
2-3 minutes.
2 Carefully separate micro-fiber
cleaning pad or bonnet from steam
cleaner (fig. 3).
3 Empty the water tank before storage.
Open the water tank cap and empty
the tank over a sink. Close the water
cap (fig. 4).
4 Wrap the power cord completely
around the base of the hand steamer
(fig. 5).
fig. 1