Filter
Top Products
HOW TO OPERATE YOUR CORDLESS VACUUM CHARGING THE CORDLESS VACUUM
1. Connect the charger jack to the charging hole on the underside of the
charging stand. (See Fig. 11) Plug the the charging transformer into the wall
outlet.
2. This vacuum cleaner is powered by Ni-Cd batteries. Before first use,
they must be charged for a minimum of 20 hours.
3. Once the batteries are fully charged, the vacuum cleaner will run for up to
20 minutes before recharging is required.
4. To recharge, simply dock the vacuum cleaner in the charging stand, with the
switch in the “off” position. Make sure that the unit is well seated and that the
charging light is illuminated. Charging times will vary depending upon the
amount of usage between charging cycles.
5. The charging light indicator (5) on the vacuum cleaner will illuminate to indicate
that the vacuum is properly charging.
Your cordless vacuum operates when the batteries are fully charged.
Before using, please ensure that the cordless vacuum is initially charged for
20 hours.
CAUTION: The Cordless Vacuum is a very powerful unit. Make
sure that you hold it firmly, otherwise it can slip out of
your hand and cause injury.
CHANGING & CLEANING THE DUST CUP FILTER
To achieve the best performance, empty the dust cup (# 1 ) and clean
the dust cup filter (# 4 ) after each use.
NOTE: Peak performance may only be realized after the
unit has been charged and discharged two (2) or
three (3) times.
1. To open the Dust Cup container, press down on the release button
and pull out the Dust Cup container (Fig. 8).
2. Pull out the Dust Cup Filter (Fig. 9).
3. Empty the dust from the Dust Cup Filter, (Fig. 10).
4. Rinse the Dust Cup Filter in warm water, and then wait until it dries
completely before replacing it into the Dust Cup container.
5. Place the Dust Cup Filter carefully into the Dust Cup container.
6. Attach the Dust Cup container to the Cordless Vacuum.
IMPORTANT: To maintain peak performance of your
cordless hand vacuum, it is recommended
that the unit be fully discharged, then
completely re-charged at least once a month.
Fig. 11
Charging
Receptacle
Fig. 8 Fig. 9 Fig. 10
NOTE: It is recommended that the dust cup filter be changed every
three (3) months to ensure peak performance of the unit.
CAUTION: The suction hole must be free of obstructions at all times.
Otherwise, the motor will overheat and could become
damaged.
4 5