Filter
Top Products
Precision Comfort™ Owners Manual
18
The two step procedure below is required to program 1 hand control to operate 1 bed.
Before beginning, make certain the bed is plugged into a working grounded electrical
outlet.
STEP 1
Locate the receiver unit (power down box)
for the bed and press the learn button
for 1 second and release (FIGURE 16).
STEP 2
On the hand control, simultaneously press
and hold the POS 1 and head massage on/
off buttons (FIGURE 17). The transmission
indicator light will flash slowly and then
flash rapidly. Continue to hold for 5
seconds and then release the buttons.
One hand control is now programmed to
operate one bed.
IF PROGRAMMING FAILS, INITIATE THE
PROGRAMMING PROCEDURE A SECOND
TIME.
NOTE
PROGRAMMING 1 hand control - 1 bed
LEARN
BUTTON
FIGURE 16: Power down box learn button.
POWER
DOWN BOX
POS 1
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 17
HEAD MASSAGE
ON/OFF BUTTON