Filter
Top Products
ENFORCER E-37EV Alarm Pager System
6 SECO-LARM U.S.A., Inc.
1
2
0
V
A
C
Transmitter
ID
Input
Receiver Display
Page LED
Zone LED
Audible / Vibrator
Indicator
Green
Positive Trigger
Green
Green
Groups of 9
Negative Trigger #1
Green
Red
Groups of 9
Negative Trigger #2
Green
Orange
Groups of 9
Manual Page
Green
Green
3 groups of 3
Power ON
Green
None
3 groups of 3
Red
Positive Trigger
Red
Green
Groups of 9
Negative Trigger #1
Red
Red
Groups of 9
Negative Trigger #2
Red
Orange
Groups of 9
Manual Page
Red
Green
3 groups of 3
Power ON
Red
None
3 groups of 3
Orange
Positive Trigger
Orange
Green
Groups of 9
Negative Trigger #1
Orange
Red
Groups of 9
Negative Trigger #2
Orange
Orange
Groups of 9
Manual Page
Orange
Green
3 groups of 3
Power ON
Orange
None
3 groups of 3
Audible and Visual Signals Chart
Operation
Receiver Switch Settings
: Beeping only ON: Vibration only OFF: Receiver off
Trigger Duration
The transmitter will transmit the page signal for a cycle of about 30 seconds, whether or not
the triggered zone is reset. If the same zone remains triggered, the transmitter will not start
a new transmission cycle. However, a new cycle will begin once another un-triggered zone
is triggered.
Manual Paging
When triggered by the manual page button the receiver will beep (or vibrate) continuously
for 1 minute in 3 groups of 3.
The Page LED will indicate which transmitter is sending the signal (Green, Red, or Orange).
The Zone LED will flash green.
Press the ON/ /OFF button after 30 seconds to stop the indicator.
Power-On Paging
When the transmitter is connected to power the receiver will beep (or vibrate) continuously
for 1 minute in 3 groups of 3.
The Page LED will indicate which transmitter is sending the signal (Green, Red, or Orange).
The Zone LED will remain blank.
Press the ON/ /OFF button after 30 seconds to stop the indicator.