Filter
Top Products
Always follow all safety precautions when
cleaning and servicing the POWER-MATE TM.
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
1. Remove light
cover by pressing
in and lifting both
sides as shown.
PushIn _ 2. Push in and turn
And Turn r_ bulb counterclock-
_ wise to remove.
3. Replace the bulb.
_ Bulb must not be
_"% higher than 15 Watts.
_---_'_ Close light cover until
it snaps in place.
NOTE: See PARTS AND FEATURES for
Bulb #.
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the POWER-MATE TM brush
and brush support areas. If build-up
becomes excessive, disconnect POWER-
MATE TM from wand and follow the steps
below. Instructions can also be found under
the light cover.
TO REMOVE BELT:
1. Remove light
cover and light
bulb as shown
under LIGHT
BULB
CHANGING.
2. Unscrew the
POWER-
MATE TM cover
screws.
3. Turn
POWER-
MATE TM over.
To remove
cover, insert
screwdriver at
cover tabs on
both sides and
twist to
release tabs.
14
4. Turn POWER-
MATE TM right
side up. Press
handle release
pedal and lower
the swivel. Tilt
Q_lck cover forward
Re/ease from back until
front snaps free.