Sears 8690290 Carpet Cleaner User Manual


 
WHEN TO EMPTY RECOVERY TANK
See Figure 9
During normal operation, your cleaner may stop recovering
solution from your carpet, When this occurs there are three
check points to alert you:
1, An increase in motor noise,
2. No solution visibly being recovered by the floor nozzle.
3. No air coming from the exhaust port of your cleaner.
When this occurs:
1. The Recovery Tank is full and the Float Valve in the
Recovery Tank has been activated. The Recovery Tank
should be emptied.
or --
2. The Recovery Tank has foam in the Tank and the Float
Valve has been activated.
NOTE: Ifcleaner is accidently turned over while in operation,
the float may activate and shut off the suction. If this occurs,
set the cleaner upright. Turn Power Switch "OFF" and let
motor come to a complete stop. Then tuna switch back on and
continue cleaning.
TO EMPTY RECOVERY TANK
See Figure 10
1. Turn Power Switch "OFF" and Disconnect Power Cord
from Electrical Outlet.
2. Disconnect Short Cord located between Solution Tank
and Recovery Tank.
3. Disconnect Vacuum Hose by depressing the Lock Button
and remove,
4. Twist Solution Tube Quick DisconnectNut counterclock-
wise; lift and remove from Quick Disconnect Valve (See
DETAIL "A" ),
5. Lift Latches on Power Head.
6. Lift power Head, by Handle, and remove from Recovery
Tank,
7, Rotate Metal Latch on the Solution Tank and lift Recovery
Tank from the Solution Tank,
8, Empty Recovery Tank.
9, Reassemble cleaner and resume cleaning. NOTE: Power
Head is designed to go on in only one ix}sition. Make sure
the word "VACUUM" on the Power Head is lined up
directly over the Hose Inlet on Recovery Tank as shown in
Fig, 10 or Power Head will not seal to unit properly,
QUICK
DISCONNECT
VALVE
RECOVERY
TANK
\\
SHORT
LATCF
DET_
RECOVERY
TANK
VACUUM
HOSE
SOLUTION
TUBING
POWER HEAD
HANDLE
ALIGN
"VACUUM"
OVER
HOSE
INLET
SOLUTION
TANK