Filter
Top Products
PROBLEM
!, Neither vacuum motor nor pump motor
runs.
2, Vacuum motor runs, but there Is no
spray at the nozzle.
3, Spray from the floor nozzle does not
come out evenly,
i
4, Motor runs but cleaner does not pick up
solution from carpet (no exhaust from
top of cleaner),
5. Spray connections leak.
POSSIBLESOLUTIONS *
1, Be sure power switch is in "ON" position,
2. Be sure power cord tsplugged In securely,
3. Check wall electrical outlet (by plugging in a known
working electrical appliance),
1, Be sure Short Cord from Power Head to Solution Tank is
securely plugged Into receptacle on the Power Head,
2, Check that Solution Tank Isfull,
3, Be sure Pump Switch is in the "HI" or _LO" position,
4, Nozzle Ports may be clogged, See Illustration below to
unclog,
!, Unclog the Nozzle Port, See Illustration below,
1, Recovery Tank isfull of dirty water and must be emptied.
2, Check for clogged hose or nozzle, Clogs could resuit from
picking up material such as carpet strings, shoe laces, etc.
I, Disassemble nut at leaking connection, Be sure washer is
properly seated, Reassemble and tighten securely,
"If the "Possible Solutions" to "Problems" iisted In the chart do not correct the problem, take your cleaner to a Sears
Service Center for professional service, Repairs not listed In this chart require prafessional and specific knowledge
of this model cleaner and could result in safely hazards and personal Injury Ifnot made by o qualified Sears Service
Technlclan.
TO UNCLOG NOZZLE PORT
See Fisu re 18
1. Insert the point of a needle or pin into Spray Port to
unclog,
NOTE: Do not let the point of needle or pin touch any
part of the Spray Pad surface or Spray Pad will not
spray solution properly,
SPRAY PORT
CAUTION: Do not let needle
or pin touch this surface,
NEEDLE OR
PIN