Filter
Top Products
Replacement and Care of Filters (continued) m
c, Install new filters in the filter housing
track with the glue beads of the wick-
ing pad to the inside of the filter hous-
ing.
d. Return the top cover of the filter
housing by installing the cover over
the fixed tabs on the rear of the lower
filter housing and pivoting the cover
down over the top of the filters, Snap
the cover over the two spring tabs.
e. Replace the filter housing in the cab-
inet. Note: There is a left and a right
filter housing. There is also a front
and back orientation. To position the
filter housings correctly:
- Make sure the two indents in the
cylinder section of the top covers are
positioned towards the center of the
cabinet.
Fixed Tabs
Spring Tabs _J
Humidifier
• Be sure that the spring tabs of filter
housings are towards front of cabi-
net.
• Align the lower portion of the filter
assembly over the six ribs located at
the boilom rear of the humidifier cab-
inet.
Top indents
Cover Towards
Center of
Cabinet
f. Position fan assembly onto the cabi-
net. Make sure the fan venturi (low-
est cylinder section below the fan) is
placed inside the filter housing,
g. Replace water bottles.
h. Close the pivoting lid.
i. The unit is ready for use or to be
stored away for next season.
NOTE: For correct operation of the filter
housing assembly, filters must be fully con-
tained inside the flange of the top cover.
Fiat Portion of Filter Housing
Towards Back of Cabinet
Indents Toward Center of Cabinet
Step 4 e.
10