Filter
Top Products
f
I Operationmstru ions
WOOD FLOORS CARE
HARD SURFACE FLOOR CARE
(VINYL, LINOLEUM,ASPHALT TILE AND NO WAX
FLOOR)
I. SCRUBBING (FLOOR STRIPPING AND
CLEANING)
DISCONNECT CORD FROM ELECTRICAL
OUTLE. DO NOT USE MACHINE TO SCRUB
WOOD FLOORS.
Attach scrubbing brushes (for scrubbing floors
with an irregular surface) or nylon scrubbing pads *
(for scrubbing floors with a smooth surface).
RemoVe dispenser tank and fill with, a stripper
and cleaner, diluted as indicated on container.
It is recommended to put the water in first to
avoid foaminq.
Do not overfill tank.Allow at least one inch air space
to avoid spilling.
Attach dispenser.
plug cord into eleclrical outlet.
Lower handle into operalJng position.
Turn swich to proper speed as indicated on the
switch box label.
Clean floor using small circular strokes,dispensing
liquid as needed.
Do not dispense liquid close to the baseboards to
avoid splashing walls.
Wipe up suds with a sponge or cloth.
Disconnect appliance. Remove and wash pads and
brushes.
I1. RENEWING THE FINISH
To renew the finish of your just cleaned floors, you
may use a protective floor finfsh.
Ill.PERIODIC MAINTENANCE
Sweep or vacuum floor frequently.
Damp mop weekly
Be sure to consult floor manufacturer for proper
maintenance.
Never use water based products on wood floors.Only
use solvent based product on wood floors.
CLEANING
Follow instructions on wood floor cleaner found on
Sears Wood Floor Care Kit, or similar product,
II. WAXING
II1.
Follow instructions on wood floor wax found on
Sears Wood Floor Care Kit, or similar product.
PdLISHING
DISCONNECT CORD FROM ELECTRICAL OUTLET.
IV.
Attach the tan polishing pads.
Make sure wax is dry before polishing,
Plug cord into electrical outlet.
Lower handle into operating position.Turn
appliance on.
Guide unit with forward and backwards strokes,
following the direclJon of the grain until the desired
finish is achieved.
Do not apply pressure,the weight of the machine is
sufficient.
Disconnect appliance remove and wash pads
BUFFING
DISCONNECT CORD FROM ELECTRICAL
OUTLET.
Attach the felt buffing pads* or the lambs wool high
luster pads.
Plug cord into electrical outlet. Lower handle into
operating position.Buffing will leave your floors
truly lustrous.
Disconnect appliance, remove and wash pads.
* NOTE'.
NYLON PADS( # 53871) AND BUFFING PADS (# 53471)NOT INCLUDED REFER TO PAGE 12,TO ORDER.
6