Filter
Top Products
(VINYL, LINOLEUM, ASPHALT TILE AND NO WAX
FLOOR)
I. SCRUBBING (FLOOR SRIPPING AND
CLEANING) DISCONNECT CORD FROM
ELECTRICAL OUTLET DO NOT USE MACHINE
TO SCRUB WOOD FLOORS.
Attach scrubbing brushes (for scrubbing floors
with an irregular surface) or nylon scrubbing
pads (for scrubbing floors with a smooth
surface).
Remove dispenser tank and fill with, a stripper
and cleaner, diluted as indicated on container.
It is recommended to put the water in first to
avoid foaming.
Do not overfill tank. Allow at least one inch
air space to avoid spilling.
Attach dispenser.
Plug cord into electrical outlet.
Lower handle into operating position.
Turn switch to proper speed as indicated on
the switch box label.
Clean floor using small circular strokes,
dispensing liquid as needed.
Do not dispense liquid close to the baseboards
to avoid splashing walls.
Wipe up suds with a sponBe of cloth.
Disconnect appliance. Remove and wash pads
and brushes.
!1. RENEWING THE FINISH
To renew the finish of your just cleaned floors,
you may use a protective floor finish.
II1. PERIODIC MAINTENANCE
Sweep or vacuum floor frequently.
Damp mop weekly.
NOTE: NYLON PADS (#53871) AND BUFFING PADS
(#53471) NOT INCLUDEDREFERTO PAGE i2, TO ORDER
OPERATION
INSTRUCTIONS
Be sure to consult floor manufacturer for proper
maintenance.
Never use water-based products on wood floors.
Only use solvent based product on wood floors.
!, CLEANING
Follow instructions on wood floor cleaner found
on Sears Wood Floor Care Kit, or similar product.
II. WAXING
Follow instructions on wood floor wax found
on Sears Wood Floor Care Kit, or similar product.
III. POLISHING
DISCONNECT CORD FROM ELECTRICAL OUTLET.
Attach the tan polishing pads.
Make sure wax is dry before polishing.
Plug cord into electrical outlet.
Lower handle into operating position. Turn
appliance on.
Guide unit forward and backwards strokes,
following the direction of the grain until the
desired finish is achieved.
Do not apply pressure, the weight of the
machine is sufficient.
Disconnect appliance, remove and wash pads.
IV. BUFFING
DISCONNECT CORD FROM ELECTRICAL OUTLET.
Attach the felt buffing pads* or the lambs wool
high luster pads.
Plug cord into electrical outlet. Lower handle
into operatin8 position. Buffing will leave your
floo_'s truly lustrous.
Disconnect appliance, remove and wash pads.