Filter
Top Products
DO NOT PLUG IN ELECTRIC CORD UNTIL
BRUSHES OR OTHER ACCESORIES HAVE BEEN
ATTACHED AND SWITCH HAS BEEN PLACED
IN THE "OFF" POSITION.
HANDLE,
SWITCH BOX AND CORD
ASSEMBLY
INSTRUCTIONS
I. Place Lower handle tube (Fig. i) into handle
tube socket "A" (Fig. 2). Fasten using bolt "B"
and internally threaded nut "C" (Fig. 3) provided
in the hardware package.
If the handle tube is difficult to assemble
(tight), insert blade of screwdriver into sl.ot
(Fig. 4) at rear of handle tube socket and twist
screwdriver gently while inserting handle tube.
2. Place upper half handle tube (Fig. 1) over
tower half. Align holes and fasten with remaining
bolt "B" and internally threaded nut "C".
3. Attach switch box to rear of upper handle
tube. Place switch box tab (no hole) into
rectangular hole (Fig° 5). Position box against
handle tube. Fasten using the small screw
provided in the hardware package. DO NOT
OVERTIGHTEN.
4. The motor cord, which goes from the switch
box to the bottom of the unit, is attached in
two (2) locations behind the dispenser at top
and bottom° The upper part of the motor cord
is snapped into place alongside the upper cord
hook on the dispenser top (Fig 6).
The lower part of the motor cord is snapped
into place between the two tower cord hooks.
They are located on the dispenser base (Fig. 7).
5. Attach lower plastic hose to rear of unit by
inserting the fitting on the end of hose into
the hole located midway at rear of unit (Fig. 8).
6. The electric cord is wound around cord hooks
as illustrated in (Fig. 9).
Note: At[ moving parts requiring lubrication
have been permanently lubricated at the
factory.
LOWER
HANDLE
TUBE
UPPER
HANDLE
TUBE
FIG. 1
FIG, 4
FIG. 6
FIG. 8
B_ _]_C
FIG. 2
C:_C
_B
FIG. 3
FIG, 5
111
FIG. 7
FIG. 9