Filter
Top Products
aNSTALLATnON
YOU MAY WANT TO CONVERT YOUR COOLER TO SIDE DISCHARGE (Figure 3)
H.n
CONVERTING COOLER TO SiDE AIR SIDE OUTLET ,_
DISCHARGE (F|G.4) DOWNOUTLET
O Remove both louvers and set them where they
will not fall See pg_ 11, "Taking Off Louver"
Q Remove four grille clips on side opposite
motor
(_ Remove a reservoir by pushing the water cros-
sover tube from the grommet and lifting out the
reservoir,, (_
(_) Remove the second reservoir as above.
Q Remove the screw that holds the wiring box,
O Remove 1,_inch diameter and _ inch diameter
knockouts,,
O Remove two plastic plugs..
® Loosen screw holding pad motor receptacle
bracket, slide bracket up and detach from
cabinet flange,. Repeat on other side,.
9 Turn cooler to side outlet position (Figure 5)
REASSEMBLY AS SIDE
OUTLET COOLER (Fig 5)
(_) Move wiring box to new location,,
O Secure wiring box with screw removed at
disassembly,
(_) Install four louver
disassembly,,
(_) Install two receptacle
disassembly°
(_ Install two plastic
disassembly
6. Assembly reservoirs, crossover tube and louv-
ers after the cooler is installed in location, Use
soap or detergent to lubricate crossover tube
before inserting into grommet, DO NOT USE
OIL.
clips removed at
brackets removed at
plugs removed at
®
ROUTE WIRES INSIDE OF PANEL
®