Filter
Top Products
uu/au/vu uu;_o "/,3"o_ 4_b UI41 3_AH_ L_]01O
Selecting a Relative Humidity Setting:
All of the settings on your dehumidifier are electronically
controlled.
50% maintains a 50% Relative Humidity level
60% maintains a 60% Relative Humidity level
70% maintains a 70% Relative Humidity level
80% maintains a 80% Relative Humidity level
"CONTINUOUS" will dehumidify "non-stop"
To select a Relative Humidity setting,
(Continuous, 50% 60%, 70%, B0%)
1. Depress the "DRY" keypad until the required setting is
selected. Each depression of the keypad will change
the relative humidity setting, identified by the
illuminated window adjacent to your selection made. (If
existing relative humidity conditions in your room
register "lower" than the relative humidity level
selected, No dehumidifying will take place (fleshing
..green window), The fan will operate but the
compressor wilt remain in an oft cycle, until the relative
humidity level is lowered accordingly (below RH level
of room),
Selecting a Fan Speed Mode:
1. To select a fan speed, each depression of the
"Fan" keypad will alternate between the "High" &
"Low" fan speed settings, identified by the
illuminated window adjacent to your selection.
Heat mode:
The Heat mode provides a featUre that will allow you the
option to setting temperatures in either "Celsius" or
"Farenheight".
NOTE: This must be accomplished before you pro-select
the HEAT mode option
It is not possible to aCcess existing ambient room
conditions during HEAT mode,
2. Depress the (_) keypad, allowing you to alternate
between the "CPF RH settings adjacent to the
LED display
3, When the window adjacent to the "C illuminates,
the LED will display temperatures in "Celsius".
4. When the window adjacent to the "F illuminates,
the LED will display temperatures in
"Farenheight". The illuminated RH window
automatically defaults to the "C (Celsius) scale
HEAT MODE:
To select nHeat", depress the "mode" key pad. Each
depression of the key pad will alternate through each of
the optiona! modes. (DRY, HEAT, FAN) When the window
adjacent to the "Heat" mode illuminates, the selection Is
complete.
Temperature;
To select]adjust "temperature" depress either of the
/ _) key pads.
The _ keypad increases temperature settings. (as
outlined below)
The _ keypad decreases temperature settings. (as
outlined below)
(Celsius scala 1"increments) Adjustable temperature
range 10"0-32"C)
(Fatenheight scala 2" increments) Adjustable temperature
range 4B"F-92" F)
The temperature appearing in the LED display ia the
temperature at which heater will cycle.
Both heater and fan will stop, when the ambient room
temperature reaches the set temperature, displayed in th*
LED window
Fan Speed,
Each depression of the "Fan" keypad will alternate
between the "High" & "Low" fan speed s_ttlngs,
identified by the illuminated window adjacent to your
selection.
• High Fan: will produce 1150 watts of Heating output
• Low Fan will produce 950 watts of Heating output
Follow these steps:
t, Depress the MODE keypad to select either DR'i
or FAN, Identified by the illuminated window
adjacent to the selection,
10