Filter
Top Products
Sew a Button
Set _he Machine
Sli"_eh selector
I
2"
Top thread _ens}on Stitch length
control ! to 4 Any number
(not necessary
to adjust)
!
Zigzag foot
_ Darning #fate
Use the darmng plate for button sewing (see p.24),
1. Set the pattern selector at " _ "',
2. A_ign the both holes of the button with the slot of the foot and place the left
hole of the button iust below the needle point.
3. Lower the foot and turn the pattern selector to ztgzag until the needle point
comes just above the right hole of the button.
4. Sew about five stitches and raise needie,
5. Set the pattern selector at " _ " again and sew a few stitches to lock
thread.
To strengthen the shank, cut the
threads leaving a 20 cm (8") tail. Bring
the needle thread down through the
hole in the button and wind it around
the shank,
Draw the thread to the wrong side and
knot,
29