Sears 153 Water Heater User Manual


 
"Froubleshooting Guide (cont'd)
CONDENSATION
Whenever the water heater is filled with cold water, a certain
amount of condensation wil! form while the burner is on. A
water heater may appear to be leaking when in fact the water is
condensation. This usually happens when:
When a new water heater is filled with cold water for the
first time.
When gas burns and water vapor is produced in water
heaters, particularly high efficiency models where flue tem-
peratures ate lower.
, When you use large amounts of hot water in a short time
and the refill water is very cold.
Moisture from the products of combustion condense on the
cooler tank surfaces and fbrm drops of water which may fall
onto the burner or other hot surfaces to produce a "sizzling" or
"frying" noise.
Excessive condensation can cause pilot outage due to water run-
ning down the flue tube onto the main burner and putting our
the pilot.
Because the suddenness and amount of water, condensation
water may be diagnosed as a "tank leak". After the water in the
tank warms up (about 1-2 hours), the condition should disap-
pear.
Do not assume the water heater is leaking until there has been
enough time for the water in the tank to warm up.
An undersized water heater will cause more condensation. The
water heater must be sized properly to meet the family's demands
for hot water including dishwashers, washing machines and
shower heads.
Excessive condensation may be noticed during the winter and
early spring months when incoming water temperatures are at
their lowest.
Good venting is essentia! for a gas fired water heater to operate
properly as well as to carry away products of combustion and
water vapor.
A'WARNING
HOTTER WATER CAN SCALD: Water heaters are intended to
produce hot water. Water heated to a temperature which will
satisfyclothes washing,dish washing,and other sanitizingneeds
can scaldand permanently injure you upon contact. Some peo-
ple are more likelyto be permanen_ injured by hot water than
others. These includethe elderly,children,the infirm, or physical.
! ly/mentatlyhandicapped.If anyone usinghot water inyour home
fits into one of these groupsor ifthere isa localcode or state law
requiring a certain temperature water at the hot water tap_then
you must take specialprecautions. In additionto usingthe lowest
possibletemperature sett ngthat satisfiesyour hot water needs,
_ _a means suchasa mixing valve, shouldbe usedat the hot water
taps used by these people or at the water heater. Mixing valves
are availableat plumbingsupplyor hardwarestores.Follow man-
ufacturers instructions for installation of the valves. Before
changing the factory setting on the thermostat, read the
t 'Temperature Regulation' sectionin this manual.
SIOKEIODOR
It is not uncommon to experience a small amount of smoke and
odor during the initial start-up. This is due to burning off of oil
from metal parts, and will disappear in a short while.
Operational Conditions
SHELLY WATER
In each glasslined water heater there is installed at least one
anode rod (see parts section) for corrosion protection of the
tank. Certain water conditions will cause a reaction between this
rod and the water. The most common complaint associated with
the anode rod is one of a "rotten egg smell". This odor is derived
from hydrogen sulfide gas dissolved in the water. The smell is
the result of four factors which must all be present for the odor
to develop:
a. a concentration of sulfate in the supply water.
b. little or no dissolved o:cygen in the water.
c. a sulfate reducing bacteria within the water heater. (This
harmless bacteria is non-toxic to humans.)
d. an excess of active hydrogen in the tank. This is caused by
the corrosion protective action of the anode.
Smelly water may be eliminated or reduced in some water heater
models by replacing the anode(s) with one of less active material,
and then chlorinating the water heater tank and all hot water
lines, Contact Sears Service for further information concerning
an Anode Replacement Kit #9001453 and this Chlorination
Treatment.
If the smdly water persists after the anode replacement and chlo-
rination treatment, we can only suggest that continuous chlori-
nation and filtering conditioning equipment be considered to
eliminate the water problem.
Do not remove the anode leaving the tank unprotected. By
doing so, all warranty on the water heater tank is voided.
"AIR" IN HOT WATER FAUCETS
AWARNING
HYDROGEN GAS: Hydrogen gas can be produced in a hot
water system that has not been used for a long period of time
(generally two weeks or more). Hydrogen gas is extremely
flammable and explosive. To prevent the possibility of injury
under these conditions, we recommend the hot water faucet
be opened for several minutes at the kitchen sink before any
electrical applianceswhich are connected to the hot water sys-
tem are used (such as a dishwasher or washing machine). If
hydrogen gas is present, there will probably be an unusual
soundsimilar to air escapingthrough the pipe as the hot water
faucet is opened. There must be no smoking or open flame
near the faucet at the time it is open.
23