Filter
Top Products
ONE-PIECE DOORS
Please read and comply with the warningsand
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag
screws (not provided) to the top of the door.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"x1-112" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SIZE
©
Nut5,16Hii r,a eBo,tL kwash r5, 6"
IIIIIIIIIIIIIIIIIIII!IIIIIII!IIIIIID
5116"-18x2-1i2"
Header Wall
2x4SuppoH
--Finished Ceiling--
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
doer with glass panel etc.)
(not provided),
For a door withno exposed framing,
orfor the optional installation, use
5/16"x1-1/2" lag screws (not provided)
to fasten door bracket,
25